For a deck in Gainesville, posts and any wood touching or near the ground should be UC4A (ground contact) pressure-treated lumber. The wood preservation standards allow UC3B (above ground) for deck boards, railings and, in some cases, joists and beams, but they also say framing that is hard to replace or that stays damp should be treated to ground-contact levels. In North Central Florida's heat and humidity, we treat the whole frame as ground contact.
What the Use Categories Mean
The American Wood Protection Association (AWPA) sorts treated wood into use categories by how harsh the exposure is. The ones you will see at a lumber yard:
- UC3B, above ground, uncoated: outdoor wood that gets wet but drains and dries. AWPA lists deck boards, deck railing and, with conditions, joists and beams here.
- UC4A, ground contact, general use: posts, ledgers, stair stringers that touch the ground, landscape walls and planter boxes.
- UC4B, ground contact, heavy duty: critical structural parts that are very hard to replace, such as permanent wood foundations.
The higher the category, the more preservative is pushed into the wood. The difference shows up years later, mostly in places you cannot see.
Why Joists and Beams Get the Upgrade
AWPA's own chart footnotes joists and beams: above-ground parts that are difficult to replace and critical to the structure may need ground-contact treatment. Field reports back that up. Deck framing built with above-ground lumber has shown decay in about a decade, mostly along the tops of joists where water sits under the deck boards.
A Gainesville deck checks every box for that kind of trouble:
- Long, humid summers with frequent afternoon storms, so the frame rarely dries all the way out.
- Many decks sit low over shaded, damp ground under tree cover.
- Leaves and debris collect on top of joists and between boards.
Some treated-lumber producers require ground-contact framing for their warranty to apply to joists, ledgers and beams. The cost difference on a typical deck frame is small compared with replacing joists under finished decking later.
How to Read the End Tag
Every piece of treated lumber should carry a plastic tag or stamp on the end. It lists the brand, the preservative, the retention level, the AWPA standard and the use category, for example UC4A or Ground Contact. If you are getting quotes, it is fair to ask which category the framing will be, and to see the tags on delivery day. Keep a few tags with your house paperwork; they matter if you ever file a warranty claim.
What Treated Lumber Does and Does Not Do Against Termites
Pressure treatment protects the wood itself from decay fungi and termites, which is why it is required anywhere wood is close to soil. It does not protect untreated wood nearby, and cut ends lose some protection unless they are brushed with an end-cut preservative. Untreated wood forms left in the ground, scrap lumber under the deck, and mulch piled against posts all invite termites to the area. Our crews treat cut ends, clean out scrap, and keep a gap between soil and the lowest wood.
The Rest of the Deck
- Hardware: today's copper-based treatments are hard on plain steel. Use hot-dip galvanized or stainless connectors and fasteners rated for treated lumber.
- Deck boards: UC3B treated pine, cedar or composite all work. Composite boards still sit on a treated wood frame, so the framing rules above still apply.
- Repairs: when we replace rotted joists on an older deck, we match or upgrade to UC4A so the new wood outlasts the old. See our deck repair and restoration page for how we decide between repair and replacement.
Every custom wood deck we build in Gainesville and Hawthorne uses ground-contact framing as standard. Once the frame is built, the next question is usually finish: see when to stain a new pressure-treated deck. The footings under that frame are covered in deck footing depth in Gainesville.
Planning a Deck in Alachua County?
We will look at your yard, talk through options and send a written price with no obligation.
π Call 352-450-5850